 |
Materials (1) Spraymate (2) Hangar brackets (4) Nuts & Bolts (2) Washers |
|
 |
Step One Unfold Spraymate |
|
 |
Step Two Place Spraymate on a flat surface with the white side facing down. |
|
 |
Step Three Fold outside creases up to a 90 degree angle. |
|
 |
Step Four Fold bottom to form trough. Push open slot from front side. |
|
 |
Step Five Fold end crease to outside edge with the side edge on the inside. Slide tab into slot. |
|
 |
Step Six Trough should look as pictured above when completed. Bolt holes should line up when assembled correctly. |
|
 |
Step Seven Install hangar brackets at the top of Spraymate at desired height. Insert bold through both bracket and Spraymate on front side. Washer and nut should be attached to the back of Spraymate. |
|
©2000 Spraymate.com; All Rights Reserved